Progress so far on out with the old and in with the new
2 posters
Page 1 of 1
Progress so far on out with the old and in with the new
Just got all the cleaning jobs now, Gearbox oil change, painting, re-locating firetech, drilling new holes for new fuel lines, got some requests for help on a few nits.
1. fitting a CB Performance fuel pump to a switch in the cab area.
2. Steering Column switch required if anyone has one for the fuel pump.
3. will be changing the rear left wheel brake cylinder so need help with that and bleeding brakes.
4. Just putting the finishing bits to new engine so hope all jobs done by end Feb.
Ron
Ronnieboy59- Club Member
- Posts : 568
Join date : 2011-02-12
Age : 64
Location : Andover
Part 2
Just cleaning and swapping over under engine tinware, got to try to get the firesleeve over the oil hoses and its tight, May need help tweeking the carbs as they are only pre-set by book, thats if the thing fires up, have learnt a great deal over the last year or two so thanks to all.
Was thinking of addind a breather catch tank as the rocker covers are already prepped, i also could fit the fuel pump block of breather to it also, would prefer minimal hoses so if anyone has any ideas then drop a note on here.
Thanks
Ron
Ron
Ronnieboy59- Club Member
- Posts : 568
Join date : 2011-02-12
Age : 64
Location : Andover
Re: Progress so far on out with the old and in with the new
Well done Ron,
Just a thought but see you have urethane gearbox mounts they are more rigid but bloody noisy ... rubber is much better from my experience.
Just a thought but see you have urethane gearbox mounts they are more rigid but bloody noisy ... rubber is much better from my experience.
Grizzly- Club Member
- Posts : 1358
Join date : 2011-02-04
Location : Hampshire
Similar topics
» Anybody know of a machine shop that can line bore a case
» Engine fitting THIS WEEKEND now with pics
» Engine fitting THIS WEEKEND now with pics
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|